House Wall Hanging (slightly imperfect)

This batch of House wall hangings has a very slight imperfection that was made during the laser cutting process. Whoops! I used the wrong setting. You probably wouldn't see it unless I told you to look for it but I couldn't keep it from you. The edges on the acrylic pieces have a border where the acrylic had a little too much heat. You probably won't see it unless you go in direct sunlight and look at it from an angle. (The last photo shows it). For this reason this piece has been discounted.

These houses are looking for a forever home.

This 2D sculpture has been made to hang on a wall.
Made and designed in the Melbourne based Almost Iris studio in small batches.

Made from Birch Plywood and Acrylic. The acrylic has been sourced from local factory off-cuts.

Measurement & Weight:
14cm tall, 15cm wide, 0.6cm thick
52 grams
(As this piece isn't square; measurements are approximate from widest points)

Each wall hanging comes with a 3M velcro hanging strip which is also renter friendly.

Please note the Birch Plywood will naturally darken to a warmer hue over time with UV exposure. This is a natural feature of the wood.